B&K CT310 Manuale Utente Scaricare il pdf (Pagina 37)

CT600/602/610 and CT300/310 BKC-DIP Product Specific Appendices

Version 2.00.09

Updated 12/15/06

Page 37 of 48

(00, X, 2, 1=1;cs16) Turn Z1 power on (unit not in Sleep)

(00, X, 2, 2=0;cs16) Turn Z2 power off (unit in Sleep)

NOTE: A Power State Command “on” is referred to as a “Warm Boot”.

Cold Boot Command: (receiveID, X, 6; cs16)

This forces the unit to do a “Cold Boot”, which is the same sequence of events that occur when the

unit is turned on from the power on/off switch. This differs from a “Warm Boot” (Power State

Command with On/Off state of 1) in that all of the unit’s hardware is re-initialized.

NOTE: After issuing a Cold Boot command, the unit’s communication port is reinitialized.

Communication will have to be re-established. The unit cannot receive BKC-DIP

commands until the Update Unit “BKC-DIP ACTIVE” reply has been transmitted by the

unit (see Update Command below for further details).

Factory Reset Command: (receiveID, X, 7; cs16)

This command executes the factory-reset sequence in the unit. The factory reset returns the state

of the unit to its original factory settings.

WARNING!: Issuing a Factory Reset Command will destroy all user modified data in the

unit (preset, system settings, etc.).

NOTE: After issuing a Factory Reset command, the unit’s communication port is reinitialized.

Communication will have to be re-established. The unit cannot receive BKC-DIP

commands until the Update Unit “BKC-DIP ACTIVE” reply has been transmitted by the

unit (refer to the Update Command in the BKC-DIP Specification for further details).

Unsupported Executive Commands

The following Executive Commands are not supported by the CT610/310/600:

Noise Generator State Command: (receiveID, X, 3, noiseState; cs16)

Noise Steering Command: (receiveID, X, 4, speakerIndex=onOff, ... speakerIndex=onOff; cs16)

Noise Increment Command: (receiveID, X, 5; cs16)

Reinitialize BKC-DIP State Command: (receiveID, X, 8;cs16)

Test Tone State Command: (receiveID, X, 9, level; cs16)

Mute State Command: (receiveID, X, A, z=muteState; cs16)

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Nessun commento

B&K CT310 Manuale Utente Pagina 37